Megado Minerals (ASX:MEG) has received final assays from Phase 1 drilling at its Iberian Copper Project in northern Spain and has submitted a Phase 2 drilling proposal with the provincial administration, according to a company filing dated 20 November 2026.

Key Points

  • Three drill holes totalling 939.5m were completed within the Etayo Investigation Permit at the Iberian Copper Project in Navarra and Aragón, northern Spain
  • Drill hole ET-01 returned assay highlights of 0.55m at 0.84% Cu and 11g/t Ag from 75.05m, including 0.25m at 1.39% Cu and 18g/t Ag from 75.05m
  • Combined downhole and surface IP geophysical survey on drill hole ET-04 identified near-surface chargeability anomalies at multiple dipole positions
  • Phase 2 drilling proposal has been submitted to regional administrative bodies, with approval anticipated to take one to two months

Phase 1 Drilling Results at Mina Emilia

Megado completed three drill holes within the Etayo Investigation Permit targeting depth and lateral extensions to the historic Mina Emilia copper carbonate mine. Drill hole ET-01, angled at -45° 005° to an end-of-hole depth of 260.1m, intersected interbedded sandstones and lutites of the Mues Unit with minor chalcocite mineralisation adjacent to and at depth below the southernmost adit. A second hole, ET-01bis, was drilled from the same pad at a steeper angle of -60° 005° to 296.3m but did not intersect significant copper mineralisation, with the absence attributed to a lack of organic matter accumulations in that hole.

Third Drill Hole and Geophysical Survey Findings

A third drill hole, ET-04, was completed at a depth of 383.1m, located 5.6 kilometres east of Mina Emilia. No organic matter or copper mineralisation was observed and no samples were submitted for assay. A combined downhole and surface induced polarisation (IP) test survey was conducted on ET-04. The survey identified chargeability anomalies at multiple dipole positions, with measured values exceeding 30 milliseconds at dipole 4 for current injection at depths of 160, 180 and 200 metres. Additional anomalous chargeability values were recorded at dipoles 3 and 5 at various electrode depths.

Phase 2 Drilling Proposal and Next Steps

Megado has notified regional administrative bodies of its intent to undertake Phase 2 drilling within the Etayo and Eslava Investigation Permits, targeting extensions to mineralisation at historical copper mines along strike from identified prospective stratigraphic units. The drilling approval process is anticipated to take one to two months. The exact scope, timing and commencement of any follow-up program remain subject to Board approval, drill rig and contractor availability, drilling permits and funding. The company is also re-checking the upward continuation of the chargeability anomalies to determine whether any surface expression exists.